Electronic Fan Controller v2

Included:

• Electronic Fan Controller
• Temperature Sensor with 1 ft pigtail cable
• 1 meter/3.3 ft cable
• Instruction Manuel

Settings
Connect the power supply and the load, you can supply to the controller,
Is displayed as a measured temperature,
Press the SET button, the display flashes the temperature,
Press -&+ to set the desired temperature,
After setting press SET to confirm the return,
The controller automatically performs the relay by setting off!
Long press SET 5 seconds to enter the main menu settings,
Press the + – toggle P0 … P8 long press SET,
10 seconds of no key activity confirmed their return to the controller.

Code        Description                   Setting range         Factory setting

P0            Cooling /Heating                           C/H                              C
P1             Hysteresis setting                         0.5-15                            2
P2            Highest setting upper limit             110                             110
P3            Lowest setting upper limit               -50                             -50
P4            Temperature correction                -7-7℃                             0
P5            Delay start time                        0-10 Minutes                     0
P6            High-temperature alarm               0-110℃                        OFF

Lights, LED status descriptions:
Indicator: Off The relay is switched off, Always indicate the relay is closed.

Display:

LL is the sensor open.
HH is out of range, the thermostat will be forced to close the relay.
— as high-temperature protection.

Note: Relay output interface is a switch when it working, these two ports are connected. If not work, these two ports are not connected.